Features
This is an Electrically Detected Magnetic Resonance (EDMR) device to detect the ESR phenomenon as a change of electric current.
Sample：Diode "1N4007"
Specifications
EDMR controller
| Input impedance | 100 kΩ to 1 GΩ (9 ranges) |
|---|---|
| Bias output voltage | CV, CC mode; 0 to 1 V or 0 to 10 V / CR mode ; 0 to 10 V |
| Bias output current | 0 to 100 μA |
| Dedicated cell material | Synthetic Quartz, 5 mm (OD) |
Composition
Amplifier ：1 set
Dedicated cell ：Clip electrode type (for pellet type samples)
Without electrode type (for samples with lead wire) two eachConnection cable ：1 set
Note
1) Select the bias output voltage from <1 V, or <10 V.
2) 80Hz modulation coil is needed for EDMR measurements. Select the correct model depending on ESR system basic unit.
More Info
Are you a medical professional or personnel engaged in medical care?
No
Please be reminded that these pages are not intended to provide the general public with information about the products.